To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Transmission Mount Transmission-Side Bracket Replacement


2421193

Callout

Component Name

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

   • Identify how to disable high voltage.
   • Identify how to test for the presence of high voltage.
   • Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.
Failure to follow the procedures exactly as written may result in serious injury or death.

Preliminary Procedures

  1. Remove the left transmission mount from the vehicle. Refer to Transmission Mount Replacement - Left Side .
  2. Remove the range selector lever cable bracket. Refer to Range Selector Lever Cable Bracket Replacement .

1

Fastener (Qty: 5)

Caution: Refer to Component Fastener Tightening Caution in the Preface section.

Caution: This component is equipped with torque-to-yield fasteners. Install a NEW torque-to-yield fastener when installing this component. Failure to replace the torque-to-yield fastener could cause damage to the vehicle or component.

Procedure

Tighten in the sequence shown.

DO NOT reuse the bolts. Discard and replace with NEW bolts only.

Tighten
50 N·m (37 lb ft) plus 50 degrees

2

Transmission Side Bracket

   


&#169© Copyright Chevrolet. All rights reserved