To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Transmission Fluid Cooler Inlet Pipe Replacement


2414213

Callout

Component Name

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

   • Identify how to disable high voltage.
   • Identify how to test for the presence of high voltage.
   • Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.
Failure to follow the procedures exactly as written may result in serious injury or death.

Preliminary Procedure

  1. Disable hybrid high voltage system. Refer to High Voltage Disabling  and High Voltage Enabling
  2. Remove the drive motor generator power inverter module. Refer to Drive Motor Generator Power Inverter Module Replacement
  3. Remove the front wheelhouse front liner on the driver side. Refer to Front Wheelhouse Front Liner Replacement

1

Transmission Fluid Cooler Inlet Pipe Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten
22 N·m (16 lb ft)

2

Transmission Fluid Cooler Inlet Pipe Quick Connect Fitting

Procedure

Disconnect the transmission pipe from the transmission fluid cooler thermal bypass valve quick connect fitting. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection

3

Transmission Fluid Cooler Inlet Pipe

   


&#169© Copyright Chevrolet. All rights reserved