To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Stabiliser Shaft Replacement


2374440

Callout

Component Name

Preliminary Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the stabiliser shaft link from the stabiliser shaft. Refer to Stabilizer Shaft Link Replacement .

1

Front Stabiliser Shaft Insulator Clamp Bolt (Qty: 2)

Warning: This component is equipped with torque-to-yield fasteners. Install a NEW torque-to-yield fastener when installing this component. Failure to replace the torque-to-yield fastener could cause bodily injury and damage to the vehicle or component.

Caution: This component is equipped with torque-to-yield fasteners. Install a NEW torque-to-yield fastener when installing this component. Failure to replace the torque-to-yield fastener could cause damage to the vehicle or component.

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Lower the Drivetrain and Front Suspension Frame Assembly. Refer to Drivetrain and Front Suspension Frame Replacement .

Tip
Lower the front suspension frame assembly enough to gain access to the stabiliser shaft insulator bolts.

Tighten

  1. First Pass: 22 N·m (16 lb ft).
  2. Final Pass: 40 degrees.

2

Front Stabiliser Shaft

Tip
The stabiliser shaft insulator and the clamps are serviced with the stabiliser shaft. They are Not service separately.

   


© Copyright Chevrolet. All rights reserved