To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Drive Motor Battery Coolant Pump Replacement


2375107

Callout

Component Name

Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.

Preliminary Procedure

  1. Drain the coolant. Refer to Drive Motor Battery Cooling System Draining and Filling
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  3. Remove the drive motor battery coolant pump inlet hose from pump. Refer to Drive Motor Battery Coolant Pump Inlet Hose Replacement
  4. Remove the drive motor battery coolant inlet hose from pump. Refer to Drive Motor Battery Coolant Inlet Hose Replacement

1

Generator Control Module Coolant Pump Bolts (Qty: 2).

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)

2

Generator Control Module Coolant Pump.

Tip
Disconnect the electrical connector.

   


© Copyright Chevrolet. All rights reserved