To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Rear End Spoiler Replacement


2382067

Callout

Component Name

Preliminary Procedures

  1. Open and support the rear tailgate assembly.
  2. Remove the liftgate trim finish panel. Refer to Liftgate Lower Trim Finish Panel Replacement
  3. Disconnect the high mount brake lamp electrical connector from the tailgate main electrical harness.

1

High Mount Brake Lamp Electrical Connector

2

Rear End Spoiler Screw (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
2.5 N·m (22 lb in)

3

Rear End Spoiler Nut (Qty: 6)

Tighten
6 N·m (53 lb in)

4

Rear End Spoiler Retainer (Qty: 4)

Tip
Replace any broken retainers and ensure the water management foam gaskets are all in place prior to securing the rear end spoiler to the tailgate.

5

Rear End Spoiler

Procedure

Transfer the high mount brake lamp. Refer to High Mount Brake lamp Replacement

   


© Copyright Chevrolet. All rights reserved