To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Steering Wheel Airbag Coil Replacement


2019039

Callout

Component Name

Preliminary Procedures

  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
  2. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
  3. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .

1

Steering Wheel Inflatable Restraint Module Coil Bolt (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
1.5 N·m(13 lb in)

2

Steering Wheel Inflatable Restraint Module Coil

Procedure

  1. Disconnect any electrical connectors as necessary.
  2. Use tape in order to secure the old coil in the centre position.
  3. Remove the old coil from the steering column.
  4. Transfer the steering angle sensor. Refer to Steering Angle Sensor Replacement .
  5. Ensure the coil is centred during installation. If you are installing a NEW coil, ensure the centring tab is on the coil. If the coil is not centred, refer to Inflatable Restraint Steering Wheel Module Coil Centring .
   


© Copyright Chevrolet. All rights reserved