To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Transmission Mount Replacement - Left Side


2400634

Callout

Component Name

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

   • Identify how to disable high voltage.
   • Identify how to test for the presence of high voltage.
   • Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.
Failure to follow the procedures exactly as written may result in serious injury or death.

Preliminary Procedures

  1. Remove the drive motor generator power inverter module from the vehicle. Refer to Drive Motor Generator Power Inverter Module Replacement .
  2. Install the engine support fixture. Refer to Engine Support Fixture .
  3. Prior to removing the mount, mark the mount location using spray paint or a marker for correct positioning during installation.

1

Nut (Qty: 1)

Caution: Refer to Component Fastener Tightening Caution in the Preface section.

Caution: This component is equipped with torque-to-yield fasteners. Install a NEW torque-to-yield fastener when installing this component. Failure to replace the torque-to-yield fastener could cause damage to the vehicle or component.

Tighten
50 N·m (37 lb ft)

2

Bolt (Qty: 2)

Tighten
58 N·m (43 lb ft)

3

Bolt (Qty: 3)

Tip
DO NOT reuse the bolts. Discard and replace with NEW bolts only.

Tighten

    • First pass: 100 N·m (74 lb ft)
    • Final pass: additional 90-105 degrees

4

Left Transmission Mount

   


&#169© Copyright Chevrolet. All rights reserved