To the top of the document
Volt
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Battery Positive Cable Replacement

Removal Procedure

  1. Remove the rear floor stowage compartment. Refer to Rear Compartment Floor Stowage Trim Compartment Replacement .
  2. Disconnect the battery negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .

  3. 2595433
  4. Unlock the retaining tab (2) on the battery fuse box cover.
  5. Open the battery fuse box flap (1).
  6. Note: Pull the battery fuse box housing. DO NOT pull the flap.

  7. Unlock the retaining tab (3) and open the battery fuse box cover.

  8. 2374800
  9. Remove the battery positive cable fuse block nut (1) and terminal (2) from the battery fuse block.
  10. Remove the quarter inner trim finish panel. Refer to Quarter Inner Trim Finish Panel Replacement .
  11. Separate the battery positive cable from the body harness, while working from the rear compartment towards the passenger compartment.

  12. 2374799
  13. Remove the rear side door floor covering retainer. Refer to Rear Side Door Opening Floor Carpet Retainer Replacement .
  14. Detach the battery positive cable (1) from the rear passenger compartment.

  15. 2374795
  16. Remove the interior trim panels (1). Refer to Centre Pillar Trim Panel Replacement and Front Side Door Opening Floor Carpet Retainer Replacement .
  17. Remove the battery positive cable (2) from the left rocker channel.

  18. 2374796
  19. Detach the battery positive terminal (2), from the engine wiring junction block (3), with the nut (1).

  20. 2374797
  21. Pull the battery positive cable (2) through the harness grommet (1).
  22. Remove the battery positive cable from the vehicle.

Installation Procedure


    2374797
  1. Push the battery positive cable terminal (2) through the grommet (1) and into the front engine compartment.
  2. Caution: Refer to Fastener Caution in the Preface section.


    2374796
  3. Install the battery positive cable terminal (2) to the engine wiring junction block (3). Tighten the nut (1) to 17 N·m (12 lb ft).

  4. 2374795
  5. Install the battery positive cable into the rocker channel below the interior trim panels (1).

  6. 2374799
  7. Secure the battery positive cable (1) to the body harness, while transfering the remaining cable into the rear compartment.

  8. 2374800
  9. Attach the battery positive cable to the body harness along the left rear wheelhouse.
  10. Install the battery positive cable terminal (2) to the battery fuse block and tighten nut (1) to 12 N·m (106 lb in).

  11. 2595433
  12. Close the battery fuse box cover (1) and lock the retaining tabs (2, 3).
  13. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection
  14. Install the quarter inner trim finish panel, rear compartment floor stowage trim panel and the interior trim panels. Refer to Quarter Inner Trim Finish Panel Replacement , Rear Compartment Floor Stowage Trim Compartment Replacement , Rear Side Door Opening Floor Carpet Retainer Replacement , and Front Side Door Opening Floor Carpet Retainer Replacement .
   


© Copyright Chevrolet. All rights reserved