Captiva

Sump Replacement

Special Tools

EN 46109 Guide Pin Set

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Install the engine support fixture. Refer to Engine Support Fixture .
3. Remove the front cover. Refer to Engine Front Cover Replacement
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
5. Drain the engine oil and remove the oil filter. Refer to Engine Oil and Oil Filter Replacement .
6. Remove the catalytic converter.
7. Remove the air conditioning (A/C) compressor. Refer to Air Conditioning Compressor Replacement : Diesel  → V6  → 2.4L .
8. Remove the oil pan bolts.
9. Remove the sump.
10. Clean the oil pan and the engine block gasket surface. Refer to Sump Cleaning and Inspection .

1. Install the 8 mm (0.315 in) guides from the EN 46109 into the centre sump rail bolt hole on each side of the engine block.



2. Place a 3 mm (0.118 in) bead (1) of RTV sealant on the block pan rail and the crankshaft rear oil seal housing. Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended sealant.



3. Position the sump onto the block.



4. Remove the EN 46109 8 mm (0.315 in) guides from the engine block.



5. Loosely install the sump bolts.

Caution: Refer to Fastener Caution in the Preface section.




6. Tighten the sump bolts in sequence shown.

•	Tighten the 8 mm bolts (1-11) to 23 N·m (17 lb ft).

•	Tighten the 6 mm bolts (12, 13) to 10 N·m (89 lb in).

7. Install the air conditioning (A/C) compressor. Refer to Air Conditioning Compressor Replacement : Diesel  → V6  → 2.4L .
8. Install the catalytic converter.
9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
10. Refill the engine oil. Refer to Engine Oil and Oil Filter Replacement .
11. Install the front cover. Refer to Engine Front Cover Replacement
12. Remove the engine support fixture. Refer to Engine Support Fixture .
13. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .