Captiva

Brake Pedal Assembly Replacement - LHD

1. Remove the driver knee bolster reinforcement. Refer to Driver Knee Bolster Replacement : Long Body  → Short Body .
2. Remove the accelerator pedal position sensor. Refer to Accelerator Pedal with Position Sensor Assembly Replacement : LE5 or LE9 (2.4L), or Accelerator Pedal Position Sensor Replacement (3.0L), or Accelerator Pedal Position Sensor Replacement (2.0L, 2.2L Diesel).
3. Remove the brake lamp switch. Refer to Stop Lamp Switch Replacement .



4. Remove the brake booster pushrod retainer (1).
5. Disconnect the brake booster pushrod from the brake pedal pivot pin.



6. Remove the brake pedal bracket bolt (1).
7. Remove the instrument panel assembly. Refer to Instrument Panel Assembly Replacement : Long Body  → Short Body .



8. Remove the vacuum brake booster nuts (1) and the brake pedal assembly.

1. Install the brake pedal assembly.

Caution: Refer to Fastener Caution in the Preface section.

2. Install the vacuum brake booster nuts (1) and tighten to 22 N·m (16 lb ft).



3. Install the instrument panel assembly. Refer to Instrument Panel Assembly Replacement : Long Body  → Short Body .
4. Install the brake pedal bracket bolt (1) and tighten to 22 N·m (16 lb ft).
5. Connect the brake booster pushrod to the brake pedal pivot pin.



6. Install the brake booster pushrod retainer (1).
7. Ensure the pushrod retainer is properly installed by rotating the retainer 360 degrees.
8. Install the accelerator pedal position sensor. Refer to Accelerator Pedal with Position Sensor Assembly Replacement : LE5 or LE9 (2.4L), or Accelerator Pedal Position Sensor Replacement (3.0L), or Accelerator Pedal Position Sensor Replacement (2.0L, 2.2L Diesel).
9. Install the brake lamp switch. Refer to Stop Lamp Switch Replacement .
10. Install the driver knee bolster reinforcement. Refer to Driver Knee Bolster Replacement : Long Body  → Short Body .