Captiva

Brake Pedal Assembly Replacement - RHD

1. Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement : Long Body  → Short Body .
2. Remove the accelerator pedal position sensor. Refer to Accelerator Pedal with Position Sensor Assembly Replacement : LE5 or LE9 (2.4L), or Accelerator Pedal Position Sensor Replacement (3.0L), or Accelerator Pedal Position Sensor Replacement (2.0L, 2.2L Diesel).
3. Disconnect the brake pedal position sensor electrical connector.



4. Remove the power vacuum brake booster pushrod nut (1).
5. Disconnect the power vacuum brake booster pushrod from the brake pedal.



6. Remove the power vacuum brake booster nuts (1).



7. Remove the brake pedal bracket bolts (1).
8. Remove the instrument panel assembly. Refer to Instrument Panel Assembly Replacement : Long Body  → Short Body .
9. Remove the brake pedal assembly.

1. Position the brake pedal to the power vacuum brake booster studs.

Caution: Refer to Fastener Caution in the Preface section.




2. Install the power vacuum brake booster nuts (1) and tighten to 22 N·m (16 lb ft).
3. Install the instrument panel assembly. Refer to Instrument Panel Assembly Replacement : Long Body  → Short Body .



4. Install the brake pedal bracket bolts (1) and tighten to 22 N·m (16 lb ft).



5. Install the power vacuum brake booster pushrod to the brake pedal.
6. Install the power vacuum brake booster pushrod nut (1) and tighten to 9 N·m (80 lb in).
7. Connect the brake pedal position sensor electrical connector.
8. Install the accelerator pedal position sensor. Refer to Accelerator Pedal with Position Sensor Assembly Replacement : LE5 or LE9 (2.4L), or Accelerator Pedal Position Sensor Replacement (3.0L), or Accelerator Pedal Position Sensor Replacement (2.0L, 2.2L Diesel).
9. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement : Long Body  → Short Body .