To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Water Pump Replacement - LNQ

Special Tools

BO 38185 Hose Clamp Pliers

For equivalent tools, refer toSpecial Tools .

Removal Procedure

  1. Drain the cooling system. Refer to Cooling System Draining and Filling .
  2. Remove the air conditioner compressor. Refer to Air Conditioning Compressor Replacement : Diesel  → V6  → 2.4L .
  3. Remove the drive belt. Refer to Drive Belt Replacement .
  4. Remove the diesel particulate filter. Refer to Exhaust Particulate Filter Replacement : LNQ .
  5. Remove the radiator outlet hose. Refer to Radiator Outlet Hose Replacement : Diesel  → V6  → LE5 .

  6. 2484079
  7. Disconnect the following from the water pump:
  8. • Thermostat bypass hose (1)
    • Engine coolant inlet hose (2)
    • Water pump inlet hose (3)

    2484087
  9. Remove the water pump bolts (1) and discard the seal (2).
  10. Remove the water pump (3) from the engine compartment.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    2484087
  1. Install the water pump (3) with a NEW seal (2) and tighten the bolts (1) to 25 N·m (18 lb ft).

  2. 2484079
  3. Connect the following to the water pump:
  4. • Thermostat bypass hose (1)
    • Engine coolant inlet hose (2)
    • Water pump inlet hose (3)
  5. Install the radiator outlet hose. Refer to Radiator Outlet Hose Replacement : Diesel  → V6  → LE5 .
  6. Install the air conditioner compressor. Refer to Air Conditioning Compressor Replacement : Diesel  → V6  → 2.4L .
  7. Install the drive belt. Refer to Drive Belt Replacement .
  8. Install the diesel particulate filter. Refer to Exhaust Particulate Filter Replacement : LNQ .
  9. Fill the cooling system. Refer to Cooling System Draining and Filling .
   


© Copyright Chevrolet. All rights reserved